jan2 Posted February 5, 2009 Report Share Posted February 5, 2009 Sometimes after a Modflow run GMS 6.5 gives the message "sorting contours" but does not progress after a certain percentage. Is this a common problem and are there ways to avoid it? Quote Link to comment Share on other sites More sharing options...
Sean Czarniecki Posted February 5, 2009 Report Share Posted February 5, 2009 This often happens when the number of contours is too high for GMS to work with. For example, if you are looking at your entire model domain and have heads ranging from 0 to 100 ft, but you are asking for a 0.1 ft interval (because you previously had zoomed in on an area and wanted more detail), you might run into this problem and it will get hung up. Change your interval to a larger number to start. Once you zoom into an area, you can go back to the smaller interval again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.