pagesk 0 Posted April 22, 2020 Report Share Posted April 22, 2020 As in the title PreSRH-2D stopped due to the following "Number of nodes exceeded 500 in sec_str.f90 Weir_up Error Code is: 502" Immediately before this message, the Command Line box said "***TVF file is read in successfully" I do not have a weir in my model. The only thing I would suggest is unusual about this model is that it has "internal sinks" to simulate local run on in addition to the normal inlet Qs at the defined channels. Anywhere to suggest to start trouble shooting? Quote Link to post Share on other sites
Donald Hendon 0 Posted April 22, 2020 Report Share Posted April 22, 2020 Do you have any BC lines that have more than 500 nodes? I would start there. Quote Link to post Share on other sites
pagesk 0 Posted April 22, 2020 Author Report Share Posted April 22, 2020 The internal sink arcs are defined by two nodes and a couple of vertices. But the arcs are long, several thousand feet, so they cross many mesh cells. If you think that may be the cause I could probably shorted the arcs or split the flow between several shorter arcs. Thanks Quote Link to post Share on other sites
Donald Hendon 0 Posted April 22, 2020 Report Share Posted April 22, 2020 Definitely worth a try. It would make sense since it is say 500 nodes. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.