hadeel3294 Posted September 28, 2019 Report Share Posted September 28, 2019 (edited) hello everybody i have a problem with my model and i hope you could help i have complex stratigraphy. so first i used Modflow-USG , you can see the figure of my U-grid in the attached figure, I tried to add a recharge at the top cell but i couldnot >>I searched and the solution was adding a new upper inactive layer, but i could not add it , i hope you help me do this and tell me the steps >> i also tried modflow 2000 but in the step of solid-..> modflow it gave me an error similar to that i cannot find a solution please help Edited September 28, 2019 by hadeel3294 Quote Link to comment Share on other sites More sharing options...
hadeel3294 Posted September 28, 2019 Author Report Share Posted September 28, 2019 @Alan Lemon @Sean Czarniecki Quote Link to comment Share on other sites More sharing options...
Lalith Posted October 1, 2019 Report Share Posted October 1, 2019 Please make your solids bit larger than the conceptual model domain. When solids do not completely cover the grid, this error can occur. Quote Link to comment Share on other sites More sharing options...
hadeel3294 Posted October 10, 2019 Author Report Share Posted October 10, 2019 thank you very much for your reply when i made my grid cell larger the solid was created with no error Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.