W Beck 0 Posted June 13, 2017 Report Share Posted June 13, 2017 I extracted my drawn-in cross sections from the TIN to create a new cross section database (in prep for HEC RAS). When saving and exiting my .wms file, I was given the following error message (image below). Should I be concerned with this, and if so, how do I address it? Why did this occur? Thank you. Quote Link to post Share on other sites
Chris Smemoe 1 Posted June 14, 2017 Report Share Posted June 14, 2017 This error comes up if WMS does not have the location of your cross section database or if there are no cross sections or an error reading the database. I'd recommend double-clicking on your cross sections and making sure cross sections geometry is defined for each of your cross section arcs. If there's an arc without any cross section geometry defined or if there's an error loading the cross section database, that's your problem. You might have to re-extract all the cross sections to a new cross section database if some of the cross sections do not have geometry. Hope this helps, Chris Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.