Evans 0 Posted April 30, 2016 Report Share Posted April 30, 2016 Good afternoon sir Please I am a research student at University of Ghana and my project is on Groundwater modeling. i was able to finish with the stratigraphic model and am facing difficulties running the 3d conceptual model. When I run it it gives me an error stated as '' This file is not a GMS MODFLOW superfile. Assuming NAME file'' I don't know where this is coming from. Please any little help will be appreciated thanks Evans Quote Link to post Share on other sites
Bill Dolinar 1 Posted May 9, 2016 Report Share Posted May 9, 2016 This message is normal when running MODFLOW. There should be a following line saying "Using NAME file:" followed by the name of the MODFLOW file being run, followed by several lines of MODFLOW output. Quote Link to post Share on other sites
Xin 0 Posted September 12, 2020 Report Share Posted September 12, 2020 Hi I have the same problem, and the model stoped with error. However, when I check the simulation, there is no error detected. Is there anyway that I can solve this? Thank you Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.