Jump to content
GMS, SMS, and WMS User Forum

RMA2 wind setup calculation


Recommended Posts

I'm modeling the wind setup over an elongated lake approximately 12 km long and was running RMA2 to estimate the wind setup on one end of the lake. I was not sure what are the wind speed units that RMA2 uses as input. I changed the projection units to meters and I'm using m/s but there was no indication in the users manual of which wind speed units I should use to input the hourly wind speed.

Also, the lake has very minimal inflow and outflow, and I'm only interested in the wind setup. Is there a way to get away with running RMA2 with Boundary conditions of let's say fixed discharge in = discharge out, without having to specify a water level at the downstream?



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...