mahmmoud_kham Posted October 16, 2011 Report Share Posted October 16, 2011 hi how are all membersi want any one help me coz i suffer from technical problem when i try to make run for calculation it deliever error and say error in readinf .hed file plz any one know help me Quote Link to comment Share on other sites More sharing options...
Alan Lemon Posted October 18, 2011 Report Share Posted October 18, 2011 I assume you are trying to run MODFLOW. Sounds like the model did not converge. Run the model checker (MODFLOW | Model Checker...) to see if there are an obvious errors with your input. Quote Link to comment Share on other sites More sharing options...
mahmmoud_kham Posted October 22, 2011 Author Report Share Posted October 22, 2011 thx for ur concern and iwill try Quote Link to comment Share on other sites More sharing options...
houshang Posted June 19, 2012 Report Share Posted June 19, 2012 Dear sirI have also this problem and I have Run the model checker (MODFLOW | Model Checker...) . In this taske there is not any error or warning.I don't know what I should do.Best regards.Houshang Quote Link to comment Share on other sites More sharing options...
Todd Wood Posted June 19, 2012 Report Share Posted June 19, 2012 It is important to keep in mind that the model checker only checks for obvious problems with the MODFLOW input. Running the model checker in GMS and not getting any errors does not ensure that the model will converge. There are many possible causes for the model not converging, so it is difficult to determine the cause without looking at the model. That being said, below are a few general troubleshooting ideas that might be helpful in achieving convergence in MODFLOW models:check model inputs for reasonablenesstry running the model with different solvers. There are several solvers to choose from, and each of them have their own strengths and weaknesses. The default solver is the PCG2 solver, but you can try others to see if you can get the model to run. To switch solvers, select "MODFLOW | Global Options | Packages" and then select a different solver in the lower left area of the "MODFLOW Packages" dialog.try changing the solver parameterscheck the troubleshooting items for a model that is not converging can be found under item J of the Frequently Asked Questions section of the Online Guide to MODFLOWdeselect the "Enable saving of computed flows for all source/sink objects" option in the "MODFLOW | Output Control" window as this can sometimes cause problems Quote Link to comment Share on other sites More sharing options...
houshang Posted June 20, 2012 Report Share Posted June 20, 2012 Thanks for your help.i will try to do all ways that you have mentioned . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.