C. Moebus Posted April 28, 2011 Report Share Posted April 28, 2011 (edited) In GMS 8.0 the Cell Faces option was merged together with the contour options (=Block Fill) - therefore you can not display two different parameters any more with cell faces AND layer contours as you could do before.This was one of the major advantages for GMS compared to other groundwater modeling software and is lost now - being able to diplay e. g. Cell Faces (or block fill) for hydraulic conductivity AND displaying groundwater head as linear contours is essential for calibration and has to be enabled again.At the moment there is still an option to turn on "Cell faces" in 8.0, but you can not do more like choosing the (from contours independent) display parameter - for what is it used now? Edited April 28, 2011 by C. Moebus Link to comment Share on other sites More sharing options...
Alan Lemon Posted May 19, 2011 Report Share Posted May 19, 2011 The cell faces command can be used to display materials on the grid.We are bringing back the ability to display 2 different data sets at the same time on the 3D grid. Link to comment Share on other sites More sharing options...
Michael Kennard Posted September 28, 2011 Report Share Posted September 28, 2011 This is back in GMS 8.1. Link to comment Share on other sites More sharing options...
Recommended Posts