Jump to content
GMS, SMS, and WMS User Forum


  • Posts

  • Joined

  • Last visited

malibec2005uk's Achievements


Newbie (1/14)



  1. Hi, i am nolonger able to see the 2D display contour using the color fill method. the normal linear is worrking ok. Reagrds
  2. Hi, I started working with my scatter points data directly. I finished the mesh. Later I realized that I have to transfer my data to a new location. Can I transform my mesh to the new location? or do i have to start from the begining.
  3. Hi, I figure it out. The problem is after I changed the mesh I did not renumber it before saving. When I renumbered then saved everything work correctly. I saved it in the *.pts format according to my model requerments. Thanks
  4. Hi, When I modified my mesh. Then interpolate the old_mesh_file.pts to the new mesh. When I displayed the new mesh every thing seems ok. Please check the attachments Fig1. Once I save the new_file.pts and close all files. When I Open the new mesh and the new_mesh_file.pts and interpolate it again to my new mesh and display the new mesh. I found some points with zero value Fig2 in the attchments.!!!!!. I tried several times and the results are the same including some zeros. Any suggestion? Thanks Hi.doc
  5. Hi, Every time that I try to select the nodestring using the select nodestring options the program locks up along with my computer and I have to re-boot. when i tried the same file with another SMS version. it works correctly. when i start to use it again with my newer version (SMS.10) it hung up. more over when i was at my home and use SMS remotely it works fine as well??????? any advise
  6. Hi, I have the same problem. how did they solve it? thanks Mohamed Ali
  7. Hi, I work with hydrodynamic model called FVCOM which is not in the list. However in the FVCOM model manual SMS is the recommended software to construct the mesh. this information is appeard in Chapter 17 in the manual of FVCOM. The following link is for the FVCOM site. http://fvcom.smast.umassd.edu/FVCOM/index.htm
  8. Hi, I use the mesh module. i attached a picture of my mesh indicating one of the islands. I would like to define the islands and the output/input flow to the water body. thanks
  9. Hi, i am a new user for SMS. i would like to know how to identify the in/out put boundary condition points? how to identify islands insid the water body? Thanks
  • Create New...