smita pandey2 0 Report post Posted August 1, 2018 Whenever I am plotting wind vectors using the new SMS versions like 12.0, 12.2 or even 12.3 the complete wind vectors are not displayed over the domain . Here I am attaching the .png file of such plot where the right hand side wind vectors are completely not visible . it will be nice if somebody can guide over the issue. Share this post Link to post Share on other sites
Todd Wood 7 Report post Posted August 13, 2018 Hi smita, I believe what is going here is that your contours are covering the vectors in the upper portion of your mesh. To make your vectors show up above the contours, you can either add transparency to the contours in the display options or change the Origin/Offset options in the vectors tab of the display options to tell SMS to draw the vectors at a higher location. Hope this helps. Share this post Link to post Share on other sites
smita pandey2 0 Report post Posted August 14, 2018 (edited) THANKS A LOT TODD THIS SUGGESTION WORKS WELL...... Edited August 14, 2018 by smita pandey2 Share this post Link to post Share on other sites