Jump to content
GMS, SMS, and WMS User Forum
Hisham

Importing AHGW stratigraphic model

Recommended Posts

Hisham    0

Hi there

I think the easiest way to incorporate a stratigraphic model built in AHGW into GMS is through rasters.  Any practical advice on how to do this?

Thanks

Share this post


Link to post
Share on other sites
Hisham    0

Thanks Alan

 

Now I have my cross sections (2 & 3 D).  How can I use them to create rasters?

 

Thanks

Share this post


Link to post
Share on other sites
Hisham    0

Hi Alan

I guess the tool I need to use is the "Transform XS2D Lines to Points" tool.  However, I failed to run it successfully.  I set it up as shown below.  What have I got wrong there?

Thanks

59bc6c136e26a_TransformXS2DLinestoPoints.jpg.1c1aa8849cce19229787c8f39865d671.jpg

Share this post


Link to post
Share on other sites
Hisham    0

Hi again

Continued trying and managed to get the tool to run using the input shown below.  However, I didn't get points with horizon elevations as I was hoping.  In stead, I got the table shown at the bottom.  Again, any ideas will be most appreciated.

59bc71a429d33_TransformXS2DLinestoPoints.jpg.d7a526d593770e34701ca138d592b4d5.jpg

 

59bc72387f6b9_TransformXS2DLinestoPoints.jpg.4db80490c0e8df7fc4d60e364168e152.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×