Jump to content
GMS, SMS, and WMS User Forum
Sign in to follow this  
W Beck

Cross section extraction error message

Recommended Posts

I extracted my drawn-in cross sections from the TIN to create a new cross section database (in prep for HEC RAS). When saving and exiting my .wms file, I was given the following error message (image below). Should I be concerned with this, and if so, how do I address it? Why did this occur? 

Thank you. 59401d845297a_HECRASimporterror.JPG.d0fc029181954709621a8e9c5008939f.JPG

Share this post


Link to post
Share on other sites

This error comes up if WMS does not have the location of your cross section database or if there are no cross sections or an error reading the database.  I'd recommend double-clicking on your cross sections and making sure cross sections geometry is defined for each of your cross section arcs.  If there's an arc without any cross section geometry defined or if there's an error loading the cross section database, that's your problem.  You might have to re-extract all the cross sections to a new cross section database if some of the cross sections do not have geometry.

Hope this helps,

Chris

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×