Jump to content
GMS, SMS, and WMS User Forum

Calibration using PEST help


Recommended Posts

Hello all,

I am working on a model that consists of 4 different materials and 8 layers.  The model is two sand aquifers separated by clay till in places and bounded on top and bottom by clay till as well.  The model runs fine in forward mode but I can't get the pest to refine it to better than -3m error based on observation wells.  I am using the pilot point method and set the larger aquifer as the pilot points with the perched aquifer, recharge and clay till layers allowed to vary as well.  When I run the model using pest it will refine the error on or two times then all of the parameters begin to get out of bounds and are frozen.  I am using Modflow 2005 with direct solver. Current version is 10.0.11 and let me know if any more details or images are needed to help with this problem.

Any suggestions are appreciated,

Greg

Edited by myersg
Link to post
Share on other sites
  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...