Jump to content
GMS, SMS, and WMS User Forum

Does automatic calibration in GSSHA match hydrograph shape?


Sushban

Recommended Posts

GSSHA needs observed peak and volume flow data to compare calibration runs for a closeness of fit. If an observed hydrograph has multiple peaks for a single event, how will automatic calibration in GSSHA deal with that? Also, does automatic calibration in GSSHA tends to match observed peak and volume only, but not the shape of hydrograph?

Link to post
Share on other sites

I'd say rainfall, Green-Ampt infiltration parameters (especially hydraulic conductivity), and overland roughness would impact the shape of the hydrograph. The shape of your watershed will also have some impact on the shape of your hydrograph. Stream roughness values may also impact the shape. Those are basically all the main parameters in a GSSHA model. Try playing with these parameters and see how the hydrograph shape changes.

Link to post
Share on other sites
  • 1 year later...

I learned about WMS supporting PEST based auto-calibration method from this link:

http://www.xmswiki.com/xms/WMS:GSSHA_Calibration

I was trying to explore more about it but I can't find "Calibration Setup" button in WMS to set up PEST auto-calibration. I am using WMS 9.1.12 version. Does WMS support both SCE and PEST auto-calibration method?

post-8397-0-17353100-1411049476_thumb.jp

Link to post
Share on other sites

Sushban,

WMS 10.0 beta supports PEST-based auto-calibration at the outlet point. This method works much better than the previous SCE-based calibration. The link you mention above is valid for WMS 10.0 beta, which is available for download from the aquaveo.com web site and should run if you have a current license. A tutorial describing how to setup an auto-calibration model using WMS 10.0 is available on the xmswiki.com WMS tutorial page. There's a link to the tutorial from the xmswiki page you mention above. WMS 10.0 and GSSHA still support both PEST-based and SCE auto-calibration but the SCE calibration options are deprecated and will not be supported in a future version.

Thanks,

Chris

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...