Search the Community

Showing results for tags 'observation'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General
    • News
    • Forum Feedback
  • Arc Hydro Groundwater
    • Using AHGW
  • GMS
    • Using GMS
    • GMS Feature Requests
    • MODFLOW
  • SMS
    • Using SMS
    • Hydraulic Models
    • Wave Modeling
    • Other Models
    • SMS News
    • FHWA - SMS User
  • WMS
    • Using WMS
    • General Hydrology
    • Urban Hydrology
    • Hydraulics and Floodplain Modeling
    • WMS Feature Requests
    • FHWA - WMS User

Calendars

There are no results to display.


Found 3 results

  1. Hi. I'm trying to calibrate a USG groundwater model, but in my observation points (after run MODFLOW), the values of computed head is 0. why can happen that? Thank you, Bastián.
  2. From http://xmswiki.com/wiki/SMS:Observations_Workflow "Observation points are used to verify the numerical analysis with measured field data such as water surface elevation or velocity data. They are also be used to see how computed values change with time at a particular location. Observation arcs are used to view the results at a cross section or along the river profile." Question: Does the observed/calibration/measured data provided at each observation point influence the initial numerical analysis? Question: Can an observation point be used to monitor numerical analysis? This implies the creation of observation point without "observation/measured data"
  3. Hi, how do I export points from an observation coverage as a Shapefile without losing the attributes observed value and computed value? In essence, I want to export, preferably as a Shapefile, what is shown in the attached screenshot. When I save the coverage as a shapefile, the shapefile doesn't contain the attributes for the observed and computed values. Thanks for any tips and advice on this. Regards, Felix