Jump to content
GMS, SMS, and WMS User Forum

Search the Community

Showing results for tags 'layers'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General
    • News
    • Forum Feedback
  • Arc Hydro Groundwater
    • Using AHGW
  • GMS
    • Using GMS
    • GMS Feature Requests
    • MODFLOW
  • SMS
    • Using SMS
    • Hydraulic Models
    • Wave Modeling
    • Other Models
    • SMS News
    • FHWA - SMS User
  • WMS
    • Using WMS
    • General Hydrology
    • Urban Hydrology
    • Hydraulics and Floodplain Modeling
    • WMS Feature Requests
    • FHWA - WMS User

Calendars

There are no results to display.


Found 3 results

  1. mapping solids to a 3D grid

    Hi, I have built 3D solids using borehole data of quite complex geology. It has so many layers of soil types. However, I do not feel that I should assign layers for each soil type because it will make too many layers to analyze. Should I?. Also, some soil layers do not run across the entire domain. I was thinking these solids should be mapped to a 3D grid with three or four layers with similar hydrogeological characteristics. Can someone please guide me how I should map these data to a 3D grid modflow grid with few layers? Am I going in the proper direction in modeling this? Thank you, Lalith
  2. Mapping Material Properties in GMS

    I have created materials in a GMS model, and assigned the materials to different modflow layers. The material characteristics such as hydraulic conductivity that I have assigned to each material do not seem to be mapped to the layers in the modflow model. If I assign Hk and Hv within each layer's attribute table it works correctly, but when I assign materials to a layer it does not seem to work. Am I doing something wrong?
  3. heads in different layers

    Hi, I have a GMS modflow model with multiple layers (9 layers). I used about 200 observed heads for calibration. These observed head values are in different layers. I want to check how successful the calibration is in each layer. Currently, all observed heads are visible and it is hard to recognize what head is at what layer. Is there a way that I can see the observed heads that are in a selected layer only? I tried orthogonal mode on but it still shows all observed heads regardless of the active layer in orthogonal mode. This model is in GMS version 9.0. Thank you, Lalith
×