Jump to content
GMS, SMS, and WMS User Forum

SAKURA1

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About SAKURA1

  • Rank
    Member

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Dear Aquaveo GMS users and Developer, I am trying to use pilot points calibration as the tutorial https://www.youtube.com/watch?v=kaFgRRPsifo to groundwater model calibration in my case study. Unfortunately, I got an error like the attached file. Does anyone have the experience to solve this issue? please help me. Thank you very much, An,
  2. Dear Sean Czarniecki, Thank you very much for your kind reply. If these warnings do not influence the accuracy of modeling results I will go to the next steps. Kind regards, An,
  3. Dear Sean Czarniecki, Thank you very much for your kind reply. I would like to fix the Warning: Cell dimensions change more than 50% between cells i=1, j=1, k=3, and i=1, j=1, k=4. Could you please give a solution to fix it? Kind regards, An,
  4. Dear Lalith, Thank you very much for your reply. I solved the problem but I got other errors as the attached figure. Would you please give me advise on solving these errors? Kind regards, An,
  5. Dear Lalith, Thank you very much for your help. Unfortunately, I cannot solve this problem. You can see in the Figure after extending the boundary of the study area the Model created another error. Could you or everybody please help me to solve it. If you don't mind I could send my model to your email then you could check it easily. Again, thank you very much for your great help. Yours sincerely, An,
  6. Dear Sir/Madam, I tried to create a Modflow model from Solid layers using Aquaveo GMS 10.4 but I got an error like the attached figure. Do you have the experience to solve this error? Please help me! Thank you very much, Yours sincerely, T.An,
×
×
  • Create New...