Jump to content
GMS, SMS, and WMS User Forum

Leaderboard


Popular Content

Showing content with the highest reputation on 12/10/2010 in all areas

  1. 1 point
    Hi, Have you checked to see whether the inflow through the boundary is what you are specifying? I found that adcirc didn't get fluxes right for the pipeflow wier boundary condition and so it may have a problem here as well. Specify a flux that runs without the errors and then check in the results that the actual flux is what you put in. If the flux turns out to be much greater than expected then you will have to edit the code to correct this error. Hope this helps a little Ian
×
×
  • Create New...